* [BGP]Adding configuration knob to allow advertise Loopback ipv6 /128 prefix
By default when IPv6 address is configured with /128 as subnet mask in Loopback0 interface, it will be advertised as prefix with /64 subnet.
To control this behavior a new field 'bgp_adv_lo_prefix_as_128' is introduced in DEVICE_METADATA table which when set to true will advertise prefix with /128 subnet as it is.
Why I did it
resolves#8979 and #9055
How I did it
Remove the file static.conf.j2,which adds the default route on eth0 from bgp docker
Signed-off-by: Arvindsrinivasan Lakshmi Narasimhan <arlakshm@microsoft.com>
- Support for non-template based FRR configurations (BGP, route-map, OSPF, static route..etc) using config DB schema.
- Support for save & restore - Jinja template based config-DB data read and apply to FRR during startup
**- How I did it**
- add frrcfgd service
- when frr_mgmg_framework_config is set, frrcfgd starts in bgp container
- when user changed the BGP or other related table entries in config DB, frrcfgd will run corresponding VTYSH commands to program on FRR.
- add jinja template to generate FRR config file to be used by FRR daemons while bgp container restarted
**- How to verify it**
1. Add/delete data on config DB and then run VTYSH "show running-config" command to check if FRR configuration changed.
1. Restart bgp container and check if generated FRR config file is correct and run VTYSH "show running-config" command to check if FRR configuration is consistent with attributes in config DB
Co-authored-by: Zhenhong Zhao <zhenhong.zhao@dell.com>
frr does not advertise route if local route is not reachable, as a result
loopback route /64 is not advertised to the neighbors. Add static route
allows frr to advertise the route to its peers
Signed-off-by: Guohan Lu <lguohan@gmail.com>
The one big bgp configuration template was splitted into chunks.
Currently we have three types of bgp neighbor peers:
general bgp peers. They are represented by CONFIG_DB::BGP_NEIGHBOR table entries
dynamic bgp peers. They are represented by CONFIG_DB::BGP_PEER_RANGE table entries
monitors bgp peers. They are represented by CONFIG_DB::BGP_MONITORS table entries
This PR introduces three templates for each peer type:
bgp policies: represent policieas that will be applied to the bgp peer-group (ip prefix-lists, route-maps, etc)
bgp peer-group: represent bgp peer group which has common configuration for the bgp peer type and uses bgp routing policy from the previous item
bgp peer-group instance: represent bgp configuration, which will be used to instatiate a bgp peer-group for the bgp peer-type. Usually this one is simple, consist of the referral to the bgp peer-group, bgp peer description and bgp peer ip address.
This PR redefined constant.yml file. Now this file has a setting for to use or don't use bgp_neighbor metadata. This file has more parameters for now, which are not used. They will be used in the next iteration of bgpcfgd.
Currently all tests have been disabled. I'm going to create next PR with the tests right after this PR is merged.
I'm going to introduce better bgpcfgd in a short time. It will include support of dynamic changes for the templates.
FIX:: #4231
