### Why I did it
Unnecessary for logs to be written out to /tmp/${SERVICE}-debug.log as they are already being written to syslog. Therefore, removing writing to a new log in concern for memory space and not being able to startup some services in RO state.
##### Work item tracking
- Microsoft ADO **(number only)**:26458976
#### How I did it
Remove DEBUGLOG definition and line that echo's message to mentioned log file.
#### How to verify it
Manually verified, /tmp/${SERVICE}-debug.log files do not exist and log for service starting still appears in syslog
- Why I did it
To solve an issue with upgrade with fast-reboot including FW upgrade which has been introduced since moving to fast-reboot over warm-reboot infrastructure.
As well, this introduces fast-reboot finalizing logic to determine fast-reboot is done.
- How I did it
Added logic to finalize-warmboot script to handle fast-reboot as well, this makes sense as using fast-reboot over warm-reboot this script will be invoked. The script will clear fast-reboot entry from state-db instead of previous implementation that relied on timer. The timer could expire in some scenarios between fast-reboot finished causing fallback to cold-reboot and possible crashes.
As well this PR updates all services/scripts reading fast-reboot state-db entry to look for the updated value representing fast-reboot is active.
- How to verify it
Run fast-reboot and check that fast-reboot entry exists in state-db right after startup and being cleared as warm-reboot is finalized and not due to a timer.
Changing the default config knob value to be True for killing radv, due to the reasons below:
Killing RADV is to prevent sending the "cease to be advertising interface" protocol packet.
RFC 4861 says this ceasing packet as "should" instead of "must", considering that it's fatal to not do this.
In active-active scenario, host side might have difficulty distinguish if the "cease to be advertising interface" is for the last interface leaving.
6.2.5. Ceasing To Be an Advertising Interface
shutting down the system.
In such cases, the router SHOULD transmit one or more (but not more
than MAX_FINAL_RTR_ADVERTISEMENTS) final multicast Router
Advertisements on the interface with a Router Lifetime field of zero.
In the case of a router becoming a host, the system SHOULD also
depart from the all-routers IP multicast group on all interfaces on
which the router supports IP multicast (whether or not they had been
advertising interfaces). In addition, the host MUST ensure that
subsequent Neighbor Advertisement messages sent from the interface
have the Router flag set to zero.
sign-off: Jing Zhang zhangjing@microsoft.com
How I did it
radv sends a good-bye packet when the service is stopped, which causes a IPv6 route update on SoC side. And this update leads to an interface bouncing and causes traffic disruption even though the ToR device might already be isolated.
This PR is to mitigate the traffic disruption issue during planned maintenance, by killing radv instead of stopping. So the cease packet won't be sent.
How to verify it
Verified on dev clusters:
Traffic disruption was no longer reproducible.
radv took the killing path
if knob was off, radv would take the stopping path
sign-off: Jing Zhang zhangjing@microsoft.com
