This is to address an issue where it was observed that SAI operations sometime make take a very long to time complete (over 45ms). It was determined that the ALPM distributed thread was causing this issue.
The fix is to disable this debug thread that has no functional purpose.
Preliminary tests looks fine. BGP neighbors were all up with proper routes programmed
interfaces are all up
Manually ran the fib test cases on 7050CX3 (TD3), TD2, TH, TH2, and TH3 based platforms and
thy all passed.
as needed by SAI 3.7 and above. Without this change
Warmboot fails from 3.5 to 3.7 as Braodcoam Datastructure
gets corrupted after warm-boot.
Signed-off-by: Abhishek Dosi <abdosi@microsoft.com>
**Why I did it**
- Added support for S6000 new HWSKU-Q24S32
**How I did it**
- Modified port_config.ini, TD2 settings to bring the ports UP.
**How to verify it**
- Check LLDP neighbors,LLDP table, interface status,EEPROM and other show commands.
- Do OIR, LED, Traffic testings.
