sonic-buildimage/platform/components/docker-gbsyncd-broncos/critical_processes.j2

program:dsserve
program:syncd
[gbsyncd] Enable debug shell for BRCM broncos PHY (#12622) * Build docker-gbsyncd-broncos image * Correct typo in LIBSAI_BRONCOS_URL_PREFIX * Update docker-gbsyncd-broncos/Dockerfile.j2 * Enable debug shell support on docker-gbsyncd-broncos * Include bcmsh in docker-gbsyncd-broncos Why I did it In docker-gbsyncd-broncos image, enable debug shell support for BRCM broncos PHY. How I did it How to verify it Note: need enable attr SAI_SWITCH_ATTR_SWITCH_SHELL_ENABLE support in BCM PAI library # bcmsh Press Enter to show prompt. Press Ctrl+C to exit. NOTICE: Only one bcmsh or bcmcmd can connect to the shell at same time. BRCM:> help help List of available commands - h or help => Print command menu - l => Print list of active ports on the PHY - ps <port_id> <options> => Print port status <options> => 1 -> Link status => 2 -> Link training failure status => 3 -> Link training RX status => 4 -> PRBS lock status => 5 -> PRBS lock loss status - rd <port_id> <addr> <no of registers to read> => Read register contents - wr <port_id> <addr> <data> => Write register data - rrd <lanemap> <if_side> <addr> <no of registers to read> => Raw read register contents using lanemap and if_side (line = 0, system = 1) - rwr <lanemap> <if_side> <addr> <data> => Raw write register data using lanemap and if_side (line = 0, system = 1) - fw or firmware => Print firmware version of the PHY - pd or port_dump <port_id> <flags> => Dump port status - eyescan <port_id> => Display eye scan - fec_status <port_id> => Get fec status of the port - polarity <lanemap> <if_side> <TX polarity> <RX Polarity> => Set TX and RX polarity <lanemap> => 0xF, 0xFF, or 0xFFFF based on number of lanes <if_side > => Line = 0, System = 1 <TX/RX Polarity> =>_TX/RX Polarity bitmap of all lanes Each bit represents a lane number. E.g. Lane 0's polarity value (0 or 1) is populated in Bit 0. - polarity <lanemap> <if_side> => Print TX and RX polarity - lb <port_id> <lb_value> => Enable loopback on the port lb_value = 0 -> Disable, 1 -> PHY, 2 -> MAC - lb <port_id> => Print loopback configuration of the port - prbs <port_id> <options> <val> => Set/Get PRBS configuration <options> => 1 -> Get PRBS state and polynomial 2 -> Set PRBS Polynomial, <val> - PRBS Polynomial Please refer to phy/chip documentation for valid values 3 -> Enable PRBS <val> => 0 Disable PRBS 1 Enable both PRBS Transmitter and Receiver 2 Enable PRBS Receiver 3 Enable PRBS Transmitter exit or q => Exit the diagnostic shell 2022-11-08 19:58:25 -06:00			`program:dsserve`
Add gbsyncd container for broncos (#11154) * Add docker-gbsyncd-broncos support * Address review comments * Add socket to gbsyncd * Upgrade gbsyncd-broncos to bullseye 2022-07-17 21:57:27 -05:00			`program:syncd`