sonic-buildimage/device/arista/x86_64-arista_7170_64c/sensors.conf

# libsensors configuration file for DCS-7260CX3-64
# ------------------------------------------------

bus "i2c-6" "SCD 0000:06:00.0 SMBus master 0 bus 5"
bus "i2c-7" "SCD 0000:06:00.0 SMBus master 0 bus 6"
bus "i2c-8" "SCD 0000:06:00.0 SMBus master 0 bus 7"
bus "i2c-81" "SCD 0000:ff:0b.3 SMBus master 0 bus 0"
bus "i2c-93" "SCD 0000:ff:0b.3 SMBus master 3 bus 0"
bus "i2c-96" "SCD 0000:ff:0b.3 SMBus master 3 bus 3"

chip "max6658-i2c-8-4c"
    label temp1 "Temp sensor near ASIC"

    set temp1_max 100
    set temp1_crit 110
    set temp1_min -55

    set temp2_max 100
    set temp2_crit 110
    set temp2_min -55
    ignore temp2

chip "dps1900-i2c-6-58"
    label temp1 "PSU1 primary hotspot temp"
    label temp2 "PSU1 inlet temp"
    label temp3 "PSU1 exhaust temp"

    # setting maximum and critical thresholds is not supported for this psu
    # fault and warning limits defined internally by hardware

    ignore fan2
    ignore fan3

chip "dps1900-i2c-7-58"
    label temp1 "PSU2 primary hotspot temp"
    label temp2 "PSU2 inlet temp"
    label temp3 "PSU2 exhaust temp"

    # setting maximum and critical thresholds is not supported for this psu
    # fault and warning limits defined internally by hardware

    ignore fan2
    ignore fan3

chip "max6658-i2c-81-4c"
    label temp1 "Rear air temp1"
    label temp2 "Rear air temp2"

    set temp1_max 70
    set temp1_crit 80
    set temp1_min -55
    set temp2_max 70
    set temp2_crit 80
    set temp2_min -55

chip "lm73-i2c-96-48"
    label temp1 "Front air temp"

    set temp1_max 65